92501-92_GeneSys_Manual

5 MACHINE PREPARATION: UNPACKING Note: Immediately check, when receiving the machine, that all the materials indicated on delivery documents have been received and also that the machine has not been damaged in transit. If it has been damaged, this damage must be immediately reported to the carrier and also to our customer’s service department. Only acting promptly in this manner will make it possible to receive missing material and to be compensated for shipping damage. INTRODUCTION This is an automatic scrubber which, via the mechanical action of the rotating brush and the chemical action of a water/detergent solution, can clean many types of hard flooring. As it advances, it also collects the dirt removed and the detergent solution used to clean the floor. The machine must be used only for this purpose. Even the best machines will only work well if used correctly and kept in good working order. We therefore suggest you read this instruction booklet carefully and re-read it whenever difficulties arise while using the machine. Please contact our technical service department or your dealers if you have any questions about the machine. 1. Remove the outer packing from the machine’s shipping pallet. (Fig. 1) 2. Inspect the machine and contents for damage. Make a freight claim if machine is damaged. 3. Remove and place contents of the box away from the pallet. a. Remove interior packing materials and place away from the pallet. b.Cut all banding straps from machine. c. Use a screwdriver to remove squeegee blocks and squeegee. 4. Raise the recovery tank and connect the red battery plug. 5. Tuck the Squeegee hose behind the water sight hose so it doesn’t get run over. 6. Fold down hinged ramp at back of machine. (Fig. 2) 7. Power the unit on with the key and raise the scrub head up to transport position. 8. Slowly reverse the machine backwards down the ramp. (Fig. 2) (Fig. 1) (Fig. 2)