92425-92_CreteRx_ProceduresBrochure

STAIN remediation Prepare floor per regular maintenance practices such as dust mopping and the removal of any large foreign debris from the floor prior to using a mop or autoscrubber. Set “Wet Floor” signs and follow all other safety procedures. Dilute Betco DensiClean 0.5 oz. /gal. or 4 mL/L (1:256) with water and fill mop bucket or autoscrubber. Mop or double scrub the stained area to be restored making sure to saturate concrete; do not vacuum solution and allow a slight amount to puddle on the floor. Using the flip top quart of Betco LiquiGrind, apply at full strength to stained area at roughly 250 sq. ft. per quart. Allow five minutes of dwell time prior to the next step. Clean area with mop or autoscrubber and DensiClean solution to remove excess resin. Attach trigger sprayer to the quart of Betco Stain Defense and lightly mist the treated area (1,000 sq. ft. per quart). Quickly mop the area with a clean and dry microfiber mop spreading out the Stain Defense across the area. Allow the treated area to dry for 30 minutes. Burnish with Betco Optima propane and Betco SI Burnish pad or buff with floor machine and Betco SI Pad. Proceed with Routine Maintenance Attach Betco Honing Tools directly to pad driver on floor machine or autoscrubber. Worn, flat or brush type pad drivers will require the use of a velcro pad to hold Honing Tools. Three to six tools per pad driver are recommended. Place equipment in treatment area and begin initial honing procedure. If using the Crete Rx CRP in conjunction with Floor Machine, make 4-6 overlapping passes over the stained area at roughly 3-4 ft. / minute, or until the surface is completely smooth and etched area is removed. If operating without the Crete Rx CRP, make 20 to 50 overlapping passes. Clean area with mop or autoscrubber and DensiClean solution. Using the flip top quart of Betco Densifier, apply at full strength to stained area at roughly 500 sq. ft. per quart and spread out over the honed area with microfiber mop. Allow to dry before proceeding to next step; roughly 45 minutes depending on environmental conditions. Remove Honing Tools from equipment and replace with Betco Polishing Tools. Three to six tools per pad driver are recommended. This step to be done dry. If using the Crete Rx CRP in conjunction with Floor Machine, make 4-6 overlapping passes over the stained area at roughly 3-4 ft. / minute, or until the surface is completely smooth and etched area is removed. If operating without the Crete Rx CRP, make 20 to 50 overlapping passes. 2 7 3 4 5 8 9 10 1 6 11 12 13 Follow the procedures for Stain Remediation when floors have moderate wear, stain and etch.